DUMP TRAILER Power UNIT

DUMP TRAILER Power UNIT-DOUBLE ACTING
Standard Description
This power unit has a electrical power up electrical power down circuit with load holding on the two A & B ports. A strain compensatred flow manage is often added to circuit to regulate the decent speed on the cylinder.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean all the hydraulic components concerned just before installation of the energy unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which really should also be clean and free of impurities. N46 hydraulic oil is recommended.
4. The energy unit really should be mounted horizontally.
5. Check the oil degree inside the tank soon after the preliminary operating with the electrical power unit.
six. Oil altering is required following the initial 100 operation hours, afterwards the moment every 3000 hrs.

DUMP TRAILER Power UNIT- SINGLE ACTING
Standard Description
This power unit has a power up gravity down circuit. Start the motor to lengthen the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve is often supplied if necessary. Also a pressure compen sated movement manage may be additional on the circuit to control the descent speed of the cylinder.
Remark: Please check with our revenue engineer to the distinctive pump displacement, motor power or tank capability.
Unique Notes
one. This power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
2. Clean all of the hydraulic components concerned just before installation of the electrical power unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst,which should really also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
4. The energy unit really should be mounted horizontally.
five. Check the oil level within the tank after the first working from the electrical power unit.
6. Oil transforming is needed right after the first one hundred operation hrs, afterwards after each 3000 hours.

TAGs:

Recent Posts