Material Dealing with Power UNIT one
Standard Description
This power unit is built for that fork lift marketplace, consisting of highly efficient gear pump, DC motor, manual raise and reduce valve, tank, ect. The up and down movement are controlled from the lever of your guide release valve, that is equipped with an electrical switch to activate the motor. The lowing speed is managed by the stress compensated flow manage valve.
Specific Notes
one. The duty of this energy unit is S3, i.e. 
30 seconds on and 270 senconds off.
2. Clean all the hydraulic components concerned before set up of the electrical power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which should really also be clean and absolutely free of impurities, N46 hydraulic oil is recommended .
4. Oil changing is needed right after the initial one hundred operation hours, afterwards as soon as every 3000 hours.
5. The power unit shown is created to be mounted horizontally.
Material Dealing with Electrical power UNIT two
Basic Description
This power unit functions power up gravity down circuit. Activate the get started solenoid to begin the motor to lift the machine. The lowing motion is activated by the solenoid valve with all the decreasing velocity managed from the strain compensated flow manage valve. Solutions of this series is usually widely utilized in the industry of logistic units like fork lift, mini lift table, and so on.
Special Notes
one. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
2. Clean every one of the hydraulic parts concerned in advance of mounting the power unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst,which ought to also be clean and cost-free of impurities, N46 hydraulic oil is proposed .
4. Oil changing is required immediately after the first 100 operation hours,afterwards the moment just about every 3000 hours.
5. The power unit need to be mounted horizontally.