SMR Gearbox Set 
up
Satisfactory overall performance is dependent upon good set up. lubrication and servicing. for that reason it is necessary that the guidelines during the set up and maintenance leaflet. supplied with each and every gearbox. are followed thoroughly. a few of the critical elements of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as near for the reducer attainable, and mount reducer on driven shaft as shut to bearing as useful. failure to complete this can induce excess loads from the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive with the belt pull at roughly 90° towards the center line in between driven and input shafts. this may allow tensioning of your wedge belt drive together with the torque arm which need to ideally be in stress. if output hub runs anti-clockwise. torque arm should be positioned the proper.
3. lnstall torque-arm fulcrum on a rigid assistance to ensure the torque-arm might be at around right angles to the center line through the driven shaft and the torque arm case bolt. ensure there exists sufficient take up in the turnbuckle for belt stress adjustment.
Maintain shut.
Bell drive can be located in any effortless postion. when the torque arm should be to be used to tighten the belts, the drive must be at about tight angle to the line in between the input and output shafts.
Bell drive may be situated for the ideal if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite route to that proven from the illustration.
Torque arm and belt take up.
Torque arm could be mounted on the appropriate if wanted.
