The best way to connect O-ring Chains Remarks to connect standard O-ring Chains

1.A connecting hyperlink of an O-ring Chain for standard application is pre-coated with grease on the pins. In advance of connection, verify the grease to the surfaces of pins, and when the volume of grease is compact, apply grease with bare hands. (If gloves are applied, the grease will be absorbed by the gloves.)
Instance: Once the connecting hyperlink (I) of an O-ring chain for basic application is
shipped, O-rings are fitted in the roots with the pins. If your O-rings come loose due to vibration in the course of transport, refit the O-rings in for the roots on the pins.
In this instance, you’ll want to return the grease collected in the roots on the pins to your central surfaces in the pins, additional at portion A than at portions B proven inside the above illustration. (Portions A is worn because of sliding with the bushings.)
2.The chain may be most conveniently linked over the teeth of the sprocket. Engage the back links at the two ends of the chain with the sprocket teeth and fit connecting pins. If the sprocket might be moved, the chain may also be linked within the loosened side.
3. Connecting procedure
1.Confirm that O-rings are attached towards the roots on the pins.
two.When the amount of grease utilized around the connecting pins is smaller, coat the pins with grease on the central portions.
3.Insert the connecting pins to the bushings from the inner back links at both ends.
four.Confirm that the grease is applied for the whole encounter from the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and when pressing the connecting plate, install the spring clip. Confirm no matter if the head (the finish with no split) of the spring clip is turned in the feeding route on the chain. (See the following illustration.)
six.You’ll want to verify the spring clip is securely fitted inside the clip grooves on the connecting pins.
This completes jointing on the connecting hyperlink. Note that grease about the surfaces of connecting pins and O-rings can be removed throughout set up work. In this case, re-grease making use of the grease within the surface on the base chain or the grease during the polyethylene bag in which the connecting link was contained.


Recent Posts